Are you among those people who know only the basics of their jeep? How to begin, brake, and accelerate? You can find much more about your jeep or other vehicle that you should know. Start to see the two tail pipes at rear end of your car? Those are the visible part of the exhaust system. Yes, there exists a whole bigger exhaust system on the bottom. If you are wondering what holds it up there, this is what this post is about. It will make you know about your exhaust clamps. – Exhaust Clamps
The Exhaust Band clamps
These are used to connect two exhaust pipes. It is a clamp designed to stretch around the two pipes and make up a seal. They are available in sizes and designs. The one that includes a block between he ends with the clamps is easy to install. You will have to tighten the clamps until it locks around the blocks. If you are looking in the size of your pocket before buying a clamp, you may have to consider the ones using a foil between the ends from the clamps. These are cheaper and in addition easy to install.
For giant trucks, welding is preferable because it is stronger. It can cause holes in the exhaust system however, especially if he welding is not done right. Exhaust clamps are the other alternative. They are able to hold on very well should they have been well tightened. However, using the vibration on rough roads, they are able to become lose and noisy. If yours is an everyday jeep, you’ll be able to use the exhaust system.
You will find clamps in aluminum and stainless. The best exhaust clamps are 100% stainless-steel and do not rust. They won’t rust on your exhaust.
The U-Bolt Exhaust Clamp
This clamp was created to fold the pipe when tightened to make the seal. It isn’t advisable to use the U-bolt clamps. It is because they break when removed and aren’t in a good condition for re-use. The have excess thread that can be used to fasted to a bracket after tightening the clamp for additional support.
V-Band Exhaust Clamp
This clamp can also be commonly known as Turbo Clamp. Inside these bands is a built -in angled grooves. The grooves blend using the flange on the turbo housing and also the flange on the exhaust pipe. There are numerous kinds of the V-band exhaust clamps for sale in different designs. All you want check is to be sure you have the right diameter that’s the size of your exhaust tubes. If the diameter is right and also the groove width, the bands will easily fit in just fine. – Exhaust Clamps